Last Modified: 11-29-2007 1.6 A
Service Category: Vehicle Interior Section: Seat Belt
Model Year: 2008 Model: Sequoia Doc ID: RM000002LJS00UX
Title: SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL (2008 Sequoia)

REMOVAL

HINT:

  • Use the same procedure for the LH side and RH side.
  • The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

2. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)

(a) Remove the front seat assembly SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): REMOVAL (2008 Sequoia) .

3. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)

(a) Remove the front seat assembly SEAT: FRONT SEAT ASSEMBLY (for Power Seat): REMOVAL (2008 Sequoia) .

4. REMOVE FRONT DOOR SCUFF PLATE RH INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL (2008 Sequoia)+

5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL (2008 Sequoia)+

6. REMOVE REAR FLOOR STEP NO. 1 COVER INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL (2008 Sequoia)+

7. REMOVE REAR DOOR SCUFF PLATE RH INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL (2008 Sequoia)+

8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL (2008 Sequoia)+

9. REMOVE LOWER CENTER PILLAR GARNISH RH INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL (2008 Sequoia)+

10. REMOVE CENTER PILLAR GARNISH RH INTERIOR PANELS / TRIM: ROOF HEADLINING: REMOVAL (2008 Sequoia)+

11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

(a) Remove the nut and shoulder anchor.

(b) Disconnect the pretensioner connector as shown in the illustration.

(c) Remove the 2 bolts and front seat outer belt.

12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

(a) Remove the 2 bolts and front seat shoulder belt anchor adjuster assembly.